Woodwhiz Device Service

Firmware installation and diagnostics for Woodwhiz Toys devices

1Connect device

Connect the device to this computer with a USB data cable, select Connect and choose the device's serial port. The device is then identified automatically.

No device connected.

Device not listed? USB connection and driver help

Device not detected
  1. Use a USB data cable (charge-only cables carry no data) and a USB port directly on the computer, not a hub.
  2. Identify the device's USB interface:
  3. Install the driver for that interface from the manufacturer, reconnect the device and select Connect again. Windows 10/11 often installs the driver automatically within a minute when the computer is online.
USB interfaceTypical boardsDriver (Windows)
Espressif built-in USB
ESP32-S3, ESP32-C3, ESP32-C6, ESP32-S2, ESP32-H2
Boards without a separate USB chipNone required. If no port appears: hold BOOT, press and release RESET, then release BOOT and select Connect. For any board that connects but does not respond, hold BOOT while selecting the action. Espressif guide
Silicon Labs CP210x
CP2102, CP2102N, CP2104
NodeMCU v1.0 (ESP8266), ESP32 DevKitCSilicon Labs VCP driver (CP210x Universal Windows Driver)
WCH CH340 / CH341NodeMCU v3, Wemos D1 mini, low-cost ESP32 boardsWCH CH341SER
WCH CH9102 / CH343Newer ESP32 / ESP32-S3 development boardsWCH CH343SER
FTDI FT232R / FT231XUSB-serial adapters, some development boardsFTDI VCP driver
Prolific PL2303USB-serial adaptersDriver from Prolific Technology (prolific.com.tw)

2Install firmware

Installs the firmware released for this device. The licence and the device's settings are retained.

No firmware is published for this address. Please use the installation link provided by Woodwhiz Toys.

Device ID (required for licence activation):

3Diagnostic report

Reads the device's firmware and stored configuration (approximately one minute) and submits it to Woodwhiz Toys support. The device is not modified. The report contains the device's stored network settings and is transmitted to Woodwhiz Toys only.

4Event log

Records the device's operating messages while it runs normally, for example while a display is showing the device page. Start the log, keep this page open until the issue occurs (maximum 60 minutes), then stop and submit it.

0:00recording time
0Wi-Fi connections
0Wi-Fi disconnections
0unexpected restarts

    

Notes for Woodwhiz support (optional)

Site, contact name and a short description of the issue. Submitted together with a report or log.

About this service
  • The page communicates with the device directly through the browser (Web Serial). No software is installed on this computer.
  • Firmware is downloaded from Woodwhiz Toys over an encrypted connection and checked against the connected chip before installation.
  • Diagnostic data leaves this computer only when a report or log is submitted, or when a device is identified. It is stored privately by Woodwhiz Toys for 180 days and used for support only.
  • Supported: ESP8266 and ESP32 family devices (ESP32, -S2, -S3, -C3, -C6, -H2) with built-in USB or a CP210x, CH340, CH9102, FTDI or PL2303 interface.